Filter
Top Products
Wall Mounting
13Document Version 2008-05
Wall Mounting
1.
Remove the stand if it is attached. For information on removing the
stand, refer to page 11.
2.Attach the wall mounting adaptor
as shown.
• Make sure the cables are not
pinched by the wall mounting
adaptor. When running the cables
from the top of the unit, look
through the opening in the wall
mounting adaptor to confirm that
the cables are not being pinched.
• Slide the wall mounting adaptor in
the direction indicated until it locks
into place.
3.Drive the 2 screws into the wall
either 83 mm (3-1/4 in) or 100
mm (3-15/16 in) apart, and
mount the unit on the wall.
• You can find a wall mounting
template on page 19.
• Make sure that the wall that the
unit will be attached to is strong
enough to support the unit
(approx. 1.5 kg [3.31 lb]).
• Make sure the cables are securely
fastened to the wall.
• When this unit is no longer in use,
make sure to detach it from the
wall.
Locking the Handset Hook
Pull down the handset hook until it locks to prevent
the handset from falling off the handset cradle when
the unit is mounted to a wall or set at a high angle.
To temporarily place the handset down during a
conversation, hook it over the top edge of the unit
as shown.
83 mm
(3-1/4 in)
100 mm
(3-15/16 in)
Washer
Drive the screw
to this point.
NT321M_QRG.fm Page 13 Tuesday, January 15, 2008 4:51 PM