Filter
Top Products
6
1. Installation and Quick Start
1.4 Recording paper
A Open the cover by pressing the cover open
button (1).
B Install the recording paper.
C Insert the leading edge of the paper into the
opening above the thermal head (1).
D Pull the paper out of the unit.
L Make sure that there is no slack in the
paper roll.
E Close the cover securely by pushing down on
both sides.
F For KX-FT902:
Press {FAX/START}, then tear off the
excess paper by pulling it towards you.
For KX-FT904/KX-FT908:
Press {FAX/START} to cut the paper.
Correct
Incorrect
1
1
Note:
L If the paper is secured with glue or tape,
cut approximately 15 cm from the
beginning of the roll before installing it.
L When the power cord is connected, a
message is printed each time the cover is
opened then closed. If the recording paper
is installed upside down, the message will
not be printed. Install the paper correctly.
L For accessory information, see page 4.
{FAX/START}
FT-902-904-908HK.book Page 6 Tuesday, June 15, 2004 5:44 PM