Filter
Top Products
Operating Instructions | 15
Before Requesting Help
Problem Possible Cause Solution
No function No power Check AC cord is plugged in
(LED not lit) Not turned on Check AC adaptor is switched on
Cannot register Out of range of base Move repeater closer to base unit
(Green LED flashes) or cell station, or base or cell station
unit cell station not Repeat registration procedure
powered Check base unit / cell station is on
Handset beeping Verification tone on Switch off verification tone
Poor audio quality Out of range of base Move repeater closer to base unit/
Cell Station
Out of range of handset Move handset closer to repeater
A ringing call Delay when moving from Answer the call before moving
suddenly stops cell station to repeater beyond repeater/cell station
when moving from during incoming ring boundary
zone to zone in group ring mode
(PBX option only)
When talking and The new zone is in ‘busy Return to original zone and
moving from zone to condition’, so handover continue your call
zone, you hear an cannot occur.
alarm or continuous
noise, or your call is
disconnected.
QUQX00130YA_01_A 20/1/04 6:41 pm Page 15