Filter
Top Products
12 | Operating Instructions
Site Survey Mode (PBX option only)
This function can be used to measure the transmission quality, and identify
problematic transmission areas of the repeater installation. This function can be
used when registered or de-registered.
• Ensure the repeater is powered OFF before starting.
•To activate the site survey mode, press and
hold the switch, then Power ON, while
continuing to hold the switch.The red LED
will flash slowly.
• Continue to press and hold down the switch
for 5 seconds. When the switch is released
the green LED flashes fast and the red LED
will go OFF.
• Activate Site Survey function on handset.
The Repeater CSID is 1234567890.
•To change the site survey channel, press the
switch the required number of times (i.e twice for channel 2). The default site survey
channel is 1.
• The red LED will flash the number of times
corresponding with the channel selected.
The channel between 0 and 9 can be
selected by pressing the switch the
corresponding number of times (channel 0 =
10 times) At channel 9, one switch press will
change the channel back to 0
• Site survey mode is now operational.
•To turn OFF the site survey mode, Power OFF then repeater, then Power ON.
• Please note :1) The repeater site survey mode works independently from the PBX
cell station. This means that the PBX cell station does not have to
be placed into site survey mode.
2) When using more than 1 repeater in site survey mode
simultaneously, please ensure repeaters are set to different
channels.
For more information on how to use site survey, and for a list of compatible
handsets, please refer to the appropriate PBX Installation manual.
QUQX00130YA_01_A 20/1/04 6:41 pm Page 12