Filter
Top Products
Preparation
For assistance, please visit http://www.panasonic.com/phonehelp 13
Setting up the base unit
Connecting the AC adaptor and
telephone line cord
Connect the telephone line cord until it
clicks into the base unit (A) and telephone
line jack (B). Connect the AC adaptor cord
by pressing the plug firmly (C).
L Use only the included Panasonic AC
adaptor PQLV1 or PQLV256.
Note:
L The AC adaptor must remain connected
at all times. (It is normal for the adaptor
to feel warm during use.)
L The AC adaptor should be connected to
a vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to
a ceiling-mounted AC outlet, as the
weight of the adaptor may cause it to
become disconnected.
L The unit will not work during a power
failure. We recommend connecting a
standard telephone to the same
telephone line or to the same telephone
jack using a Panasonic T-adaptor (page
9). Emergency power can be supplied to
the unit by connecting a Panasonic
battery back-up power supply noted on
page 9.
If you subscribe to a DSL service
Please attach a noise filter (contact your
DSL provider) to the telephone line
between the base unit and the telephone
line jack in the event of the following:
– Noise is heard during conversations.
– Caller ID features (page 29) do not
function properly.
Hook
(120 V AC,
60 Hz)
To single-line
telephone jack
(RJ11C)
A
B
C
Noise filter
To single-line
telephone
jack (RJ11C)
TG563X_565X.book Page 13 Friday, February 3, 2006 4:59 PM