Filter
Top Products
Useful InformationAnswering SystemTelephone System
21
Programmable Settings
For assistance, please call: 1-800-211-PANA(7262)
Preparation
Ringer Tone
You can set the handset ringer to use one of 7 ringer patterns for outside calls.
“Tone 1” to “Tone 3” are bell ringer patterns. “Melody 1” to “Melody 4” are preset
melody patterns. The factory preset is “Tone 1”.
• You cannot change the ringer tone for intercom calls.
• If you subscribe to a Distinctive Ring Service (such as IDENTA-RING) from your
telephone company with 2 or 3 consecutive rings, select a bell ringer pattern (Tone
1 to 3). If you select a melody pattern, you will not be able to distinguish lines by
their ringers.
• If you select one of the melody ringer patterns, the ringer will continue to sound for
several seconds if:
— the caller hangs up before you answer the call, or
—
another person answers the call using another phone connected on the same
line.
LCD Contrast
There are 6 levels of LCD contrast. The factory preset is “level 3”.
1 Press [MENU].
2 Press the soft key ( ) at “Ringer
setting”.
3 Scroll to “Ringer tone” by pressing [d] or
[B], then press the soft key ( ).
4 Select the desired ringer tone by pressing
[d] or [B].
• The handset will ring and the ringer tone will
change. If the ringer volume has been turned off,
the handset will not ring (p. 20).
• You can also select the ringer tone by pressing
[1] to [7].
5 Press the soft key ( ), then press [OFF].
1 Press [MENU].
2 Scroll to “Initial setting” by pressing
[d] or [B], then press the soft key ( ).
3 Scroll to “LCD contrast” by pressing [d] or
[B], then press the soft key ( ).
4
Select the desired contrast by pressing
[
d
]
or
[
B
]
.
• The contrast will change.
• The number of steps indicates the contrast level.
5 Press the soft key ( ), then press [OFF].
Handset
SELECT
Ringer setting
SELECT
Ringer tone
Ringer tone
1:Tone 1
SAVE
Handset
SELECT
Initial setting
SELECT
LCD contrast
LCD contrast
Low High
Ex. Level 3
SAVE