Filter
Top Products
18
18
Note: Caller ID memory loss as well as one and two-touch memory loss may occur when
resetting. Therefore, please make sure that you record all important information
before you proceed with the reset.
Handset falls out of phone base when wall mounted
Handset clip was not installed properly for wall use
LINE ERROR appears on the LCD panel
• Your phone received no information or unclear call information. Static can cause this
message. If this condition persists, contact your local telephone company to ensure that
there is no problem with your phone line.
• You might have answered the phone before 2 rings.
Cannot erase all records in memory
• The DELETE button must be quickly pressed twice to erase a single call record. You
must view all new calls before you can delete all calls. To erase ALL call records, press
and hold the DELETE button for at least 5 seconds after you view all new calls.
The Caller ID display is blank
• Press either UP or DOWN button to see if “- NO CALLS -” appears.
• Check if batteries are properly installed.
• Check if you have received the first caller ID record.
Memory Dialing does not work
• Check the phone if you have programmed the numbers correctly by pressing that
memory number button. Also programming can only be done if fresh batteries are
installed correctly.
Caller’s information is not registered
• The caller may have an unlisted or blocked number to prevent caller ID identification, it
may be an overseas call, or you may have had noise on the line during that call.
• You answered the call before caller ID data was displayed, which usually occurs after
the first ring.
Pressing a memory button does not display number
• Your memory button has no stored number. Please store the number again by pressing
the [STORE] button, dialing the number and pressing the memory location button where
you want to store the number.