Filter
Top Products
≤°‡fi Cancel ≤£°‡fi
The Alarm time feature provides an alarm clock capability on system set and
analog telephones connected to an ATA or an ASM. Both room sets and common
sets can be programmed to sound an audible alert at a requested time.
One Alarm time within a 24 hour period is programmable on a room or common
set and must be reset daily. When the alarm sounds, all sets in a given room alert.
Canceling the alarm on any set cancels the alarm on all the sets in the room. A
new Alarm time entered on a room or common set overwrites any alarm set
previously.
To program the Alarm time feature on an system telephone:
1. Press ≤°‡fi. The display shows Alrm: 07:00am OFF.
If the alarm time is correct press
ON/OFF
. The display shows
Alrm:07:00am ON
.
Press
DONE
to exit.
or
To enter a new alarm time press
CHG
. The display shows
Enter time:
.
Enter a new 4 digit alarm time.
If the 24 hour clock format is used (hour: 00 to 23 and minutes: 00 to 59), no
confirmation is required. The display shows
Alarm ON hh:mm
.
If the 12 hour format is used, the display shows
hh:mm AM or PM?
. Press the
AM
or
PM
display key. The display shows
Alarm ON hh:mm
.
To program the Alarm time feature on an analog telephone:
1. Press
û¥¡àÞ. A tone sounds.
2. Enter a 4 digit alarm time.
If the 24 hour clock format is used (hour: 00 to 23 and minutes: 00 to 59), a tone
sounds.
If the 12 hour format is used, press • to select am or £ to select pm. A tone
sounds.
At the selected times, sets in the room ring to wake-up or remind the occupant of
the next event or meeting.
To cancel the Alarm time on a system telephone, press ≤£°‡fi.
The display shows
Alarm OFF
.
To cancel the Alarm time on an analog telephone press
û£¡àÞ.
When a set rings at the selected time, the occupant can release the Alarm ring as
follows:
On a system telephone, press any button except the ≥ button.
On an analog telephone lift and replace the handset back into position.
Alarm time
Alarm time:
analog phone
Cancel the
alarm
Turn off
the alarm