Filter
Top Products
21
Expansion Module 1100 Series User Guide
Chapter 3
Installing the expansion module
Complete the procedures in this chapter to install the expansion module for IP Phone 1100 Series
phones. You must have an IP Phone 1120E and IP Phone 1140E in order to use an Expansion
Module 1100 Series.
Installing an expansion module
You need a Phillips head screwdriver to complete this procedure.
1 Press the tilt lever to adjust the stand angle on the IP Phone. You can adjust the stand angle to
maximum, instead of removing the stand.
2 At the back of the IP Phone, remove the rubber plug from the AEM port.
3 Place the connecting arm of the expansion module behind the IP Phone.
4 Align the expansion module connection plug with the AEM port on the back of the IP Phone.
5 Insert the screws into the holes a the top and bottom of the connecting arm of the expansion
module.
6 Tighten the screws until they are snug.
Caution: Damage to equipment
To avoid damaging the equipment, remove the power (PeE cable or local power)
from the IP Phone before you connect the expansion module.
Adjustable stand