Filter
Top Products
Setup and assembly
15
Adjusting the tilt base
The Expansion Module stand provides a continuous tilt adjustment so the
tilt angle matches the IP Phone stand angle while accommodating
variations in the desk surface. A clamp mechanism is used to unlock and
lock the foot stand angle.
The Expansion Module is tightened by spinning the wheel clockwise and loosened
by spinning the wheel counter-clockwise.
Turn the wheel on the back right side (if viewed from the front) of the
Expansion Module to loosen the stand hinge. Adjust the angle of the IP
Phone using the tilt lever. When the IP Phone is set to a preferred angle,
turn the wheel on the back of the Expansion Module to tighten the stand
hinge and lock the stand at the same angle as the attached IP Phone.
CAUTION
Do not over tighten the wheel on the Expansion Module.