Nortel Networks 1100 Series IP Phone User Manual


 
Setup and assembly
11
Installing the Expansion Module
Use the following instructions to install the Expansion Module.
1. Press the tilt lever to adjust the stand angle on the IP Phone. You can adjust
the stand angle to maximum, instead of removing the stand. See Figure 2.
CAUTION
Damage to Equipment
To avoid damaging the equipment, remove the
power (PoE cable, or local power) from the IP
Phone before connecting the Expansion
Module.
CAUTION
Damage to Equipment
The Expansion Module is shipped with the
base locked in position. To avoid damaging the
Expansion Module, press the tilt lever, located
on the base at the front of the
Expansion
Module.
Wall Mount Lever