Filter
Top Products
7
2. Press the center of the red dot with the stylus pen.
The red dot is indicated at 25 points in order on the screen.
Press briefly on the red dot to calibrate (see top left)
Press [ESC] to cancel calibration
Press [b] to undo last point
When all points indicated by the red dot are pressed by the stylus pen, calibration is completed and the calibration
completion message is displayed on.
3. Touch
icon in the task tray by the stylus pen.
This message is popped up when calibration is completed properly.
Note:
• When Auto Run in the troubleshooting screen is checked, the software starts automatically when the computer is
started up.
• Drawing software is required to use the interactive white board function.
Drawing software cannot be downloaded from our projector support page, prepare commercially available drawing
software.