Filter
Top Products
5
Startup the Software
Preparation:
First of all, perform setup according to the installation manual enclosed
with NP03Wi.
If the computer and the camera unit are not connected by a USB cable,
the message at right would be displayed on and the software would not
be started up.
For starting up the software, Microsoft .NET Framework 4 or later is required.
If Microsoft .NET Framework is not installed on the computer, visit the website of Microsoft for download and install it on
the computer.
1. Double click the IWB icon on the desktop.
Driver installation message is displayed on.
Click OK and follow the displayed instructions for the sequel operations.
When driver installation is completed properly, IWB Setup Software is automatically launched and
icon is created in the
task tray. Clicking this icon, IWB setup menu is displayed on the screen.
Calibration Menu Display
Indicate connection status of the
camera unit and the computer
Switch to the troubleshooting
screen
Perform manual calibration
Indicate status of the stylus pen.
[Calibrated]: The stylus pen is ready to use
[Not calibrated]: Cannot use the stylus pen because calibration is not performed,
or the trouble shooting is displayed on
Close IWB Setup Menu.
* The software will continue to run.
Perform automatic ca
libration
Right click icon in the task tray and select [Exit] for finishing IWB.