NEC Dterm Analog Cordless Telephone Cordless Telephone User Manual


 
5
Replacing a Stored Number
When you enter the memory location number, any number previously stored for the memory
location is replaced.
Erasing a Stored Number
1. Remove the handset from the base unit.
2. Press memory twice.
3. Enter the memory location number (0~9) you want to erase. (You will hear a long beep
confirming the number has been erased.)
Selecting a Different Channel
You can manually change the telephone channel for clearer operation. There are 30 factory-set
channels from which you can select. (Changing channels only works when the telephone is in
use.)
1. Remove the handset from the base unit.
2. Press channel. (The talk/battery low LED flashes, indicating the telephone is changing
channels.)
3. Continue step 2 until you find a clear channel.
Traveling Out of Range
When you begin to move too far away from the base unit, you will hear a clicking sound. As you
travel further out of range, the voice transmission begins to break up. Once you have passed the
range limits of the base unit, the call terminates.
Page/Find Button
Page/find only works when the telephone is not in use.
1. Press page/find on the base unit for a five-second beep.
2. Press and hold the page/find button for a longer beep.
3. Once the handset has been located; press talk on the handset to end the page/find feature.
4. If you do not wish to make a call at this time, press talk again to hang up.