Midland Radio BR777 Two-Way Radio User Manual


 
Page 11 www.bluestarcomm.net
Model BR777
TRANSMIT (TX) PO
WER LEVEL SELECTION
Your BR777 radio has 2 power level settings. To select the power
level on any channel, press and hold the PTT button, then press the
S button to select Hi Tx Power Level setting, or press the T button to
select Lo TX Power Level setting.
If you select blank on the TX Power setting icon, then the TX Power
will be set to to Hi Power.
If you select “Lo” on the TX power setting icon, the TX Power will be
set to Lo Power.
Note : When you press the PTT button while the Battery level is
low (shown by ), the TX Power setting will change automati-
cally from Hi to Lo (if original setting is Hi)
You cannot change the TX Power setting when the radio is in
VOX mode.
SCAN
Your BR777 radio can scan all 4 channels for activity.
To enter the SCAN mode, press and hold the SCAN button for 2
seconds and release.
Your radio will rapidly scan each of the 4 channels and stop on any
active channel. Your radio will resume scanning after 4 seconds.
When you press the PTT button to transmit on an active channel, the
scanning function will stop and remain on the active channel for 5
seconds before resuming scan when the PTT button is no longer
pressed.
To exit the SCAN mode, quickly press the SCAN button while the radio
is scanning.cause low power conditions
l Be sure to set your radio to use Hi power.
!