Filter
Top Products
75-440 User manual
Page.
11
Installing/removing the belt clip
The supplied belt clip allows you to hang the transceiver on your belt or jacket when you are not using the
radio.
To fit the belt clip onto the transceiver’s body:
1) Gently slide the clip into the appropriate guides
located on the transceiver’s battery pack until it
firmly locks.
To remove the belt clip:
2) Gently move the latch located between the top
of the belt clip and the battery pack towards the
belt clip
3) Slide the belt clip off the radio.
Charging the battery pack
To charge the supplied battery pack you have to setup the charger and connect the radio as follows:
1) Connect the jack coming from the AC adapter to
the cradle’s socket.
3) Connect the AC plug of the AC adapter’s power
cable into a grounded AC power outlet.
4) Ensure that the radio is switched off.
5) Insert the radio into the cradle with the keypad
toward you (the three metallic contacts of the
battery pack must touch with the three contacts
inside the cradle).
6) Wait 10-12 hours with the standard charger 2
hours with the rapid charger and remove the
radio..
Do not remove the radio before the specified
time, otherwise the battery’s duty could be
temporarily reduced.
, Do not forget to remove the radio from slow charger after 10 to 12 hours.
, The battery charger is for indoor use only.
, For the next charges, best duty and battery life please see the chapter “Battery Packs”.
1
2
3
SLIDE DOWN
LIFT UP
PUSH