Filter
Top Products
E–5
POWER SOURCES
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery
compartment. Reversed batteries may cause damage to the device.
3. If the device is not to be used for a long period of time, remove the batteries to prevent damage or
injury from possible battery leakage.
4. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.
(Follow battery manufacturer’s directions.)
AC Power Adapter
To operate the unit using AC power, connect the AC adapter to the jack labelled
“DC 6V” on the unit and to a wall outlet having 120V, 60Hz only.
CAUTION: Use only the AC adapter provided with
the unit. Using another AC adapter may damage
the unit. When not using AC power, disconnect the
AC adapter from the wall outlet by pulling the plug
(not the cord). Do not touch the AC adapter with
wet hands.
Battery Installation
To use this unit with batteries, or to protect the memory if there is a power failure,
insert 4 “AA” size batteries (not included). To install the batteries, open the battery
compartment with a slotted screwdriver as shown
in the figure, insert the batteries following the
diagram and replace battery compartment cover.
Replace the batteries
when the Battery
indicator lights in the
display.
AC Adapter's Plug
AC Outlet
RESET SWITCH:
The RESET switch is located at the bottom of the unit. If the telephone locks
up or does not work properly, it must be reset, but the call and program
memory will be lost.
MPH-4385 (REVISED2/01).O/M.QXD 6/20/01 7:41 AM Page 6