Filter
Top Products
13
Note: When a 6400 Series display telephone is initially plugged in or after a
power outage, it can take up to 15 minutes before the time and date
appear on the screen.
Installation
The 6402 and 6402D can be either desk-mounted or wall-mounted. Use the
following directions for installing either telephone. Figure 5 shows the back of
the 6402 and 6402D telephones.
FIGURE 5 The Bottom of the 6402 and 6402D Telephones
Desktop Installation
Note: You may use the 6400 Series telephones without the desktop stand.
In this case it is suggested that you place small round feet (included in
a plastic bag in the box in which the telephone was packed) on each
corner of the bottom of the telephone housing.
1. Turn the telephone face down on a flat surface.
2. Snap one end of the line cord (D2R or D8W) into the “LINE” jack on the
back of the telephone (shown as 3 in Figure 5).
3. Thread the line cord through the routing channel leading to the top of
the desktop stand (2 in Figure 5). Make sure that the cord is placed
securely under the square tabs in the routing channel.
1
LINE
2
3
456
230738i3.book Page 13 Thursday, July 8, 1999 3:40 PM