Filter
Top Products
6
8 Local Programming Functions (Continued)
Function 44: Set Button Schedule
Access relays can be programmed to activate from a specifi c button on
multi-button transmitters. Use this function to assign a button for each
relay. Enter the button position number (0-8) for each relay. Enter # for
any relay that will not have a transmitter button assigned.
Function 52: Confi gure Onboard Relays
Access relays can be programmed to activate for different lengths of
time; be set for pulse, toggle, or latch; and set to stay latched during a
selected time zone. Use this function to confi gure each relay.
Function 55: Enter Obstacle Transmitters
One or two Model MGT Gate Safety Edge Transmitters can be
programmed into the Controller. Each obstacle transmitter can be
programmed to trigger Relay Channel C or Relay Channel D. Use this
function to enter obstacle transmitters into memory.
Function 56: Delete Obstacle Transmitters
Obstacle transmitters can be deleted from the Controller using this
function. The function will remove one transmitter at a time.
FCN 44
RLY A = RELAY A BUTTON
RLY B = RELAY B BUTTON
RLY C = RELAY C BUTTON
RLY D = RELAY D BUTTON
SET BUTTON SCHEDULE
44#RLY-A#RLY-B#RLY-C#RLY-D#
0 = NONE
1 = ANY
2 = LEFT
3 = RIGHT
4 = TOP
5 = TOP LEFT
6 = TOP RIGHT
7 = BOTTOM LEFT
8 = BOTTOM RIGHT
FCN 55
55#RLY#FC#ID#
RLY = 1 FOR RELAY C; 2 FOR RELAY D
FC = FACILITY CODE 0-15
ID = TRANSMITTER ID 0-65535
ENTER OBSTACLE TRANSMITTERS
FCN 56
56#TX NUM#
DELETE OBSTACLE TRANSMITTERS
TX NUM = 1 FOR RELAY C TRANSMITTER
2 FOR RELAY D TRANSMITTER
FCN 52
CH = 1 FOR RLY A; 2 FOR RLY B; 3 FOR RLY C; 4 FOR RLY D
TIMING = 1 FOR ACTIVATION TIME
2 FOR 1/4 SECOND PULSE ACTIVATION
3 FOR TOGGLE ON-OFF, OFF-ON
4 FOR LATCH
OPERATION = 1 FOR CONTROL; 4 FOR OBSTACLE
TZ1 = TIME ZONE NUMBER FOR RELAY HELD ON (# TO SKIP)
TZ2 = TIME ZONE NUMBER FOR RELAY HELD ON (# TO SKIP)
(SKIP TZ1 & TZ2 FOR OBSTACLE TRANSMITTERS)
TIME = ACTIVE TIME IN SECONDS (ONLY FOR MODE 1)
CONFIGURE ONBOARD RELAYS
52#CH#TIMING#OPERATION#TZ1#TZ2#TIME#