Filter
Top Products
6 7
IMPORTANT:If pairing was successful,the blue indicator light will briefly flash rapidly
before going back to flashing every 3 seconds.If unsuccessful,the light remains solid,
and you’ll need to reattempt pairing (see steps 3–5 above).
* If you have a Bluetooth phone that supports the hands-free Bluetooth profile,
see
Enhanced features section for alternative pairing instructions.Phone-
specific pairing instructions can be found online at
www.jabra.com/fscs
Turning headset on/off
5
BASIC OPERATIONS
What you hear
Quick series of 2 tones –
low to high pitch (when
active mode starts)
Quick series of 2 tones –
high to low pitch (when
standby mode starts)
3 beeps every 30 seconds
3 beeps every 5 minutes
Status
Active Mode
5
•
Call in progress
•
Up to 8 hours of talk-time*
Standby Mode
6
•
Waiting for call
•
Up to 240 hours of
standby time*
Low Battery (in active mode)
•
3 – 5 minutes of talk time left
Low Battery (in standby mode)
•
3 – 5 minutes of talk time left
What you see
Flashes every
second
Flashes every
3 seconds
3 flashes every
second
3 flashes every 3
seconds
What you do
Press and hold for 3 to 5
seconds until you see a
burst of flashes on the blue
indicator light,then release
Press and hold for 3 to 5
seconds until you see a
burst of flashes on the blue
indicator light,then release
What you hear
Ascending
(low-to-high)
tones
Descending
(high-to-low)
tones
Turning
headset on
Turning
headset off
What you see
The blue indicator
light will flash while
the power is on
(see
Status indicators
table below)
The blue indicator
light will stop
flashing
Status indicators
* Depending on phone type and usage.
IMPORTANT:Do not hold the button down for more than 3 to 5 seconds when
turning the headset on or else it may go into pairing mode,and the blue indicator light
will turn solid.If that happens,turn off the headset,wait 3 to 5 seconds,and repeat
process for turning the headset on.
Pairing
3
will create a unique and encrypted wireless link between two Bluetooth-
enabled devices such as your Bluetooth phone and JABRA FreeSpeak 250.
1. Ensure the headset is off
(see Turning
headset on/off
section).
2. Press and hold until you see a
solid
blue light (approximately 8 seconds),
then release*
(see Fig.2).
3. Set your Bluetooth phone to “discover”
the headset by following your phone’s
instruction guide.Typically,the steps
involve going to a “setup”,“connect”,or
“Bluetooth”menu
on your phone and
then selecting the option to “discover”a
Bluetooth device.
4. Your phone will find the “JABRA 250”
headset and ask if you want to pair with
it.Confirm this by pressing “yes”or “ok”.
5. Enter
passkey or PIN
4
= 0000 (4 zeros),
then press “yes” or “ok”.
“Pair” to your Bluetooth phone
4
Fig. 2
Fig. 3
English
English