Filter
Top Products
7
Mute button
Press to activate the mute circuit, cutting off the speech transmission to the
handset ( or handsfree microphone ). Press again to resume normal
conversation. The red LED, below the mute button, glows when the call is
muted and a MUTE prompt is also displayed on the LCD.
Note : The MUTE function will only operate in the on-line state and replacing
the handset will automatically release the mute function.
<
This is an edit button for use when storing numbers into memory. If a mistake
is made at the time of programming the memories, pressing the button
removes the last digit displayed on the screen ( pressing the button twice,
removes the last two digits ).
Redial
Single touch button for redialling the last number that was dialled, either
from the keypad or from a direct access memory ( maximum of 32 digits ). It
may include numbers 0-9, #, *, pause, timed break recall, off-hook, handsfree.
Memory buttons
Used for storing telephone numbers and certain access features.
There are fifteen dedicated memory buttons providing TWENTY direct access
memories. The lower set of ten buttons, provides single touch memories,
each of 24 digits capacity. The higher set of five buttons, provides five one-
touch and five two-touch memories, each of 24 digits capacity.
The following buttons are located under a cover, immediately below the LCD.