Filter
Top Products
Epygi Technologies Configuring Grandstream IP Phones on Quadro LAN
4.2 Grandstream GXP2000
To complete the automatic configuration on Grandstream GXP2000, reset the phone to factory
default settings as detailed below:
1. Press the OK key to bring up the key pad configuration UI menu, select the Config,
2. Press the OK key to enter the submenu and select Factory Reset.
3. Key in the MAC address printed on the bottom of the sticker (see the
Please Note:
above).
4. Press the OK key again to move the cursor to OK button.
5. Press the OK key again to confirm. If the MAC address is correct the phone will reboot.
Otherwise, it will exit to previous keypad menu interface.
5 Verifying Configuration
This section describes how to verify the Grandstream IP phone successful configuration:
• Go to Quadro StatusÆSIP Registration statusÆRegistered IP Lines to see if the IP
Line registration is successful.
• Dial *74 to get the line information.
• Make outgoing and accept incoming calls.
Make sure the default username set for an assigned IP
• line is displayed on the phone
display (by default it has the ‘locextNumber’ format).
PAGE 9 27-Sep-07