Filter
Top Products
Epygi Technologies Configuring Grandstream IP Phones on Quadro LAN
4.1 Grandstream BT100/200
To complete the automatic configuration on Grandstream BT100/200, reset the phone to factory
default settings as detailed below:
1. Press the Menu button on the phone for Key Pad Menu options.
2. Press the Up or Down button to see Reset.
3. Just after the rESEt” is seen on the phone LCD, enter the MAC address of the phone using
the key pad (It is a 12 digits HEX number located on the bottom of the unit).
4. Press the Menu button again to confirm the Reset.
5. Wait for phone reboot and the LCD backlight finish flashing.
Please Note: Use the following mapping for Grandstream phones to enter the MAC address:
0-9: 0-9
• A: 22 (press the “2” key twice, ”A” will show on the LCD)
• B: 222
• C: 2222
• D: 33 (press the “3” key twice "D” will show on the LCD)
If there are digits 22 in the MAC, you need to type 2 then press Æ right arrow key to move the
cursor or wait for 4 seconds to continue to key in another 2.
• E: 333
• F: 3333
PAGE 8 27-Sep-07