Filter
Top Products
Grandstream Networks, Inc. GXP User Manual Page 31 of 38
Firmware 1.1.5.15 Last Updated: 12/2007
Distinctive Ring
Tone
Caller ID must be configured. Select a Distinctive Ring Tone 1 through 3 for a particular
Caller ID. The GXP will ONLY use selected ring tones for particular Caller IDs. For all
other calls, the GXP will use System Ring Tone. When selected and no Caller ID is
configured, the selected ring tone will be used for all incoming calls.
System Ring
Tone
System ring tone. Default is North American standard.
Adjust system ring tone frequencies and cadences based on local telecom standard.
Call Progress
Tones
Using these settings, users can configure ring or tone frequencies based on parameters
from local telecom. By default, they are set to North American standard.
Frequencies should be configured with known values to avoid uncomfortable high pitch
sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing (“On time” in ‘ms’) while OFF is the period of silence. In order
to set a continuous ring, OFF should be zero. Otherwise it will ring ON ms and a pause
of OFF ms and then repeat the pattern. Up to three cadences are supported.
Disable Call
Waiting
Default is No. If set to Yes, the call waiting will be disabled.
Use Quick IP
Call Mode
Dial an IP address under the same LAN/VPN segment by entering the last octet in the IP
address.
In the Advanced Settings page there is an option "Use Quick IP-call mode". Default
setting is No. When set to YES, and #XXX is dialed, where X is 0-9 and XXX <=255,
phone will make direct IP call to aaa.bbb.ccc.XXX where aaa.bbb.ccc comes from the
local IP address REGARDLESS of subnet mask.
#XX or #X are also valid so leading 0 is not required (but OK). See Quick IP Call Mode
for details.
Lock keypad
update
If set to “Yes”, the configuration changes via keypad are disabled.
Display
Language
Allows user to choose preferred display language in web UI and key pad UI.
GXP has up to six line appearances, each with an independent SIP account. Each SIP account requires
its own configuration page. Their configurations are identical.
Table 16: SIP Account Settings
Account Active
This field indicates whether the account is active. The default value for the
primary account (Account 1) is Yes. The default value for the other two accounts
is No.
Account Name
The name associated with each account - displayed on LCD.
SIP Server
SIP Server’s IP address or Domain name provided by VoIP service provider.