Filter
Top Products
Grandstream Networks, Inc. GXP User Manual Page 30 of 38
Firmware 1.1.5.15 Last Updated: 12/2007
Allow DHCP
Option 66 to
override server
Default is Yes. This allows device gets provisioned automatically.
Authenticate
Conf File
Default is “No”. If set to “Yes”, configuration file would be authenticated before
acceptance. End user should use default setting.
Automatic
Upgrade
This function is used by ITSP. End user should NOT touch these parameters.
Default is No. Choose “Yes” to enable automatic HTTP upgrade and provisioning.
In “Check for upgrade every” field, enter the number of minutes to check the HTTP
server for firmware upgrade or configuration changes. When set to “No”, the phone will
only perform HTTP upgrade and configuration check once at boot up.
Phonebook
XML
Enable the XML phonebook via TFTP or HTTP. Define XML server path and download
interval.
Idle Screen XML
Download
Enable XML Idle Screen download via TFTP or HTTP. Define XML server path.
XML
Application
Enter server path for XML application. This option applies to GXP-2020 only.
Offhook Auto
Dial
To configure a User ID/extension to dial automatically when the phone is taken offhook.
DTMF Payload
Type
This parameter sets the payload type for DTMF using RFC2833. Default is 101.
Syslog Server
The IP address or URL of System log server. This feature is especially useful for ITSPs.
Syslog Level
Select the ATA to report the log level. Default is NONE. The level is one of DEBUG,
INFO, WARNING or ERROR. Syslog messages are sent based on the following events:
• product model/version on boot up (INFO level)
• NAT related info (INFO level)
• sent or received SIP message (DEBUG level)
• SIP message summary (INFO level)
• inbound and outbound calls (INFO level)
• registration status change (INFO level)
• negotiated codec (INFO level)
• Ethernet link up (INFO level)
• SLIC chip exception (WARNING and ERROR levels)
• memory exception (ERROR level)
The Syslog uses USER facility. In addition to standard Syslog payload, it contains the
following components: GS_LOG: [device MAC address][error code] error message
For example: May 19 02:40:38 192.168.1.14 GS_LOG: [00:0b:82:00:a1:be][000].
Ethernet link is up.
NTP server
This parameter defines the URI or IP address of the NTP (Network Time Protocol) serve.
It is used to display the current date/time.