Filter
Top Products
4
taken byall usersthat thehandset earpiece
volume switch is set to the lowest level
acceptable by each respective user. Care
should therefore be exercised to ensure
that any naive users are familiar with this
requirement.
The handset earpiece volume can be
adjusted by moving the Volume switch,
located above the handset microphone, to
High, Medium or Normal.
5 - USING THE TELEPHONE
Having connected the telephone to the
telephone socket,lift thehandset, awaitdial
tone, and dial required number. On
completion of the call, carefully replace
handset in cradle.
6 - MEMORY OPERATION
Your telephone can store up to 3 'One
touch', and 10 'Two touch' telephone
numbers. Each telephone number must
be storedin aspecific memory locationand
can be up to 21 digits long. If you wish to
store a number having more than 21 digits
(as may be required, for example, by
international numbers preceded bya3or
4 digit national operator access code), it is
suggested thatthe 3 or4 digit accesscode
is stored in a 'One touch' location and the
international number stored in any other
location.
Note :Numbers stored inthe memory may
be lostif thetelephone isdisconnected from
the telephone line.
7 - STORING TELEPHONE NUMBERS
a) 'One touch' locations
1. Ensure telephone is plugged into
telephone socket and lift handset.
2. Press
button.
3. Press one of the 'One touch' direct
memory buttons, M1, M2 or M3.
4. Dial the telephone number you wish to
store.
5. Press the
button again.
6. Repeatsteps 2 to 5 forthe remainingtwo
'One touch' locations.
7. Replace handset.
b) 'Two touch' locations
1. Ensure that telephone is plugged into
telephone socket and lift handset.
2. Press
button.
3. Press MEM button.
4. Press any button 0 to 9 on the keypad
under whichyou wishto storethe telephone
number.
5. Dial the telephone number you wish to
store.
6. Press the
button again.
7. Repeat steps 2 to 6 for any other
numbers you wish to store allocating a
different keypad number for each and then
replace the handset.
8 - DIALLING STORED TELEPHONE
NUMBERS
a) 'One touch' locations - Lift handset,
await dialtone and pressappropriate direct
memory button M1, M2 or M3. The stored
number will be dialled out automatically.
HMN