Geemarc AMPLI500 Telephone User Manual


 
20
OPTIONAL ACCESSORIES
Headset
You can also use your Ampli500™ in hands free mode with an optional Geemarc headset, this is
ideal for use with a computer screen.
To use the headset
Connect the Geemarc headset into the headset socket located
at the back of your telephone.
Press the headset key to get the dial tone
Dial the number
You can adjust the volume and tone level of calls received with the VOLUME and TONE slide
buttons located on the top of the phone (if function is active) and the sending level with the 3 position
switch located on the right side.
Neckloop
Connect the Geemarc neckloop into the neckloop socket located
at the back of your telephone.
Press SPKR to activate the neckloop and speak into the
microphone on the neckloop
The neckloop also has a volume control
Note: The Ampli500™ must be connected to the mains in order to use a neck loop.
Shaker
If you would like to be alerted to incoming phone calls by a vibrating shaker, you can use an optional
Sonic Alert bed shaker model ss12v.
Connect the shaker into the shaker socket located at the back of your phone. When an incoming call
is received, the shaker will be activated and vibrate while the phone rings.
One of the shaker settings must be selected, using the 3 position switch located on the right side of
the phone.
(See Settings chapter)
Important: only connect a Geemarc shaker, any other shaker model can damage your telephone.