Filter
Top Products
8
Press key to end the call.
On hook dialing
Dial the telephone number (delete any incorrect entries by
pressing “C” key).
Press key to carry out the conversation.
Press key to end the call.
VMWI/LED
The VMWI/LED in the handset will flash when there are new voice
message calls received. Icon turns on and the LCD display
“Message” in the call log memory.
This service need subscription to local operator and it supports the
FSK CLI system only.
Taking Calls
When an external call is received, all registered handsets and the base
station ring. EXT flashes in the handset display and, if configured, the
telephone number of the caller appears (network depended). If the
caller has been entered in your phone book, the name appears. The
incoming call VMWI/LED on the base station flashes. In the case of
an internal call or on pressing the paging key on the base station, INT
flashes in the handset display.
Handset is in the base station
Take the handset from the base station; a connection is
automatically established (when the AUTO ANS function is
active). Otherwise, press
key.
Carry out the conversation.
Press key to end the call.
Handset is not in the base station
Press key. Carry out the conversation.
Press key to end the call.
Redialing
The phone stores the last five numbers dialled in the redial
memory
Press key; the last call number dialed is displayed. Press
or key to search the required number in the redial
memory list.
Press key to carry out the conversation.
Press key to end the call.
Dialing from the Phone Book
Press key; the first entry in the phone book appears. (Or
“MEM EMPTY” if no entry)
Press or key to select the required subscriber from the
phone book. Alternatively, enter the first letter of the name
required.
Press key. The number is dialed. Carry out the
conversation.
Note: How to store entries in the phone book is explained in
the Chapter “Phone Book”.
Call Log Operations
IMPORTANT: To use the “Call Log” function, you must
subscribe to your network operator’s Caller Line Identification
(CLI) service.
Browse, Call Back, Delete, Save
If calls have been received in your absence, these are stored in the
CALL LOG memory when your telephone service has enabled this
function. The number of calls appears in the display. Incoming calls
are also indicated in the display for 10 seconds during a call.
Press key as often as necessary until CALL LOG menu
appears. Alternatively, press and hold “*” key. Then press
“INT/OK” key.