Filter
Top Products
Step 3: Connect Power Cord
Installing Your Music on Hold Adapter
1 Connect Power Cord to Module
Plug the AC power cord into the adapter jack at
the rear of the Feature Module. Thread the
power cord around the strain relief tab.
2 Connect Power Cord to Wall Outlet
Plug the AC adapter into an electrical outlet not
controlled by a wall switch.
2 Make Sure that Status Indicator lamp
is Blinking
This indicates that the feature module is prop-
erly connected to electrical power.
The blinking pattern for the Music on Hold
Adapter is a continuous rapid on and off blink-
ing.
28
800-EFM guide for PDF v1 091102.qxd 9/11/2002 2:40 PM Page 39