Filter
Top Products
Step 4: Connect Wiring Block to External Paging Adapter
Installing Your External Paging Adapter
1 Locate 8-wire Cord
Find the 8-wire cord which was enclosed with
your External Paging Adapter. Note that this is
a black cord which is approximately 6 inches
long.
Note that you must use this cord, as any other
cord may not work.
2 Connect Cord to Feature Module
Plug one end of the 8-wire cord into the jack on
the back of your External Paging Adapter
labeled “TO WIRING BLOCK.”
3 Connect other end of Cord to Wiring
Block
Plug the other end of the 8-wire cord into the
wiring block which was supplied with your fea-
ture module.
5
800-EFM guide for PDF v1 091102.qxd 9/11/2002 2:40 PM Page 12