Filter
Top Products
17
NOTE: After the answering system plays the remote menu, it will wait
10 seconds for a command. If a command is not entered, the unit
disconnects. The unit only allows two attempts at accessing the security
code. If the second attempt is incorrect, the unit will end the call.
General Product Care
To keep your answering system working and looking good, follow these guidelines:
• Avoid putting it near heating appliances and devices that generate electrical noise (for
example, motors or fluorescent lamps).
• DO NOT expose to direct sunlight or moisture.
• Avoid dropping answering system and/or other rough treatment.
• Clean with a soft cloth.
• Never use a strong cleaning agent or abrasive powder because this will damage the finish.
• Retain the original packaging in case you need to ship it at a later date.
Troubleshooting Tips
Doesn’t answer, or answers on 10th ring
• Make sure answering system is turned on.
• Memory is full, erase some messages.
• Check AC (electrical) power and phone line connections.
Incoming messages are incomplete
• Was an extension phone picked up?
• The caller left a message that is longer than the message length you chose during setup.
• Memory is full.
• You accidentally pressed the PLAY/STOP/MEMO button when you were playing back your
messages.
Won’t respond to remote commands
• You must use touch-tone phone.
• You must enter the correct security code.
• Did the unit hang up? If you take no action for a period of time, it automatically hangs up.