Filter
Top Products
IN CASE OF DIFFICULTY
In case of difficulty, check the following before seeking service.
1
,.
PROBLEM SOLUTION
No Dial
Tone
I
Dial Tone but can’t
dial out
Handset does not
ring
You experience
static, noise,orfading
in
and out
Unit
beeps.
Memory Dialing
Problems
I*
1.
2.
3.
4.
5.
6.
7.
Check Installation:
— Is BASE POWER CORD connected to a working outlet?
— Is CHARGING LIGHT lit on HANDSEP
— Do not use an outlet that can be turned ON and OFF by a wall
switch.
— Is TELEPHONE LINE CORD connected firmly to the base unit
and phone outlet?
— Is BASE ANTENNA raised?
Is CORDLESS HANDSET out of range of the base?
Make sure BATTERIES are properly charged (12 Hours).
Is the BATTERY PACK installed correctly (see page 11)?
Did the
CORDLESS HANDSET beep when you pressed the phone
button? Did the phone light come on? If not, your cordless may
need to be charged.
Disconnect CORDLESS PHONE and connect another phone to
the
same
jack. If no dial tone, then the problem may be in your wiring
or local service.
Whenever a Dower
outaae occurs, or batieries are reDlaced, the
HANDSET
m“ust be retu;ned to the BASE to reset Securiw Code
<
“
8. If you have pulse service on your line, your TONEIPULSE Switch on
the Base must be set on Pulse.
,/’
,,
‘
9. Make sure RINGER Switch on Handset is “ON”.
10. Do you have too many extension phones on your te!ephone line? Try
unplugging
someother phones.
11. Perform checks 1,2,3,4,5,6 and 7 above.
12. ISBASEANTENNA raised?
13. Is HANDSET out of range from the BASE? Move closer to BASE.
14.Does the BASE need to be relocated?
15. Is
CORDLESS BASE plugged into an outlet with household
appliances? Ifso move the appliance or telephone.
16. Check installation per 1 above. (See 7 above)
17. Charge
8ATTERYfor 12 hours.
18. Clean charging contacts on HANDSET and CRADLE with a soft cloth.
19. Check installation per 1 above.
20. Replace BATTERY.
21. Did you program the memory correctly (see page 15)?
22. Did you follow proper dialing sequence (see page 12)?
23. See 8 above.
24. Did you reprogram numbers into memory after power outage or
replacing Battery? (See Page 17)
19
,
,’