Filter
Top Products
55
Unit beeps
• Clean charging contacts on cordless handset.
• See solutions for “No dial tone”.
• Replace the battery.
Memory Dialing doesn’t work
• Did you program the memory location keys correctly?
• Did you follow proper dialing sequence?
Unit locks up and there is no communication between the base and cordless handset
• Unplug the AC power adaptor from the wall outlet and the back of the base.
Remove the handset battery. Wait for 0 seconds and plug the power adaptor
back into the base and wall outlet. Reconnect the battery and charge for 16 hours.
Handset displays "SEARCHING" or "OUT OF RANGE" and cannot link up with the base
when the TALK/CALL BACK button is pressed.
• Handset may be out of range of the base. Move closer to the base.
• Make sure the power adaptor is properly installed.
• Disconnect the handset battery and plug it in again. Place the handset on the
cradle for at least to minutes.
• Disconnect the power adaptor and plug it in again. Then place the handset on
the cradle for at least to minutes.
Handset displays "HANDSET NEEDS REGISTRATION"
• Follow the programming in the telephone procedures to re-register the handset
to the base.
• Press the SELECT button to begin handset registration. Follow instructions on
Handset screen.