Filter
Top Products
14
H
ANDSET
S
OUND
S
IGNALS
Signal Meaning
One beep every 7 seconds Battery is low
Three long beeps (with ringer on) Page signal.
A long warbling tone (with ringer on) Signals an incoming call.
One long beep Handset and Base are
not communicating: the handset
might be too far away from the base,
you might need to try another
channel, or the base might not be
receiving power.
A brief warbling tone You've stored a number in memory
successfully.
T
ROUBLESHOOTING
G
UIDE
In case of difficulty, please check the following Troubleshooting Guide
before seeking service.
Problem Solution
No dial tone • Check installation:
— Is the base power cord connected to a working
outlet?
— Is the Phone-in-Use light on?
— Is the telephone line cord connected to the wall
jack?
• Disconnect the base from the wall jack and connect
another phone to the same jack. If there is no dial tone
in the second phone, the problem might be your
wiring or local service.
• Is the handset out of range of the base?
• Make sure the battery is properly charged (12 hours).
• Is the battery pack installed correctly? See page 12.
• Did the handset beep when you pressed the phone
button? Did the Phone-in-Use light come on? The
battery may need to be charged.
• Reset the security code by placing the handset in the
base for about 20 seconds.