Filter
Top Products
1. Carefully unpack and remove your unit from the box.
2. Make sure all of the following items have been included:
3. Make sure the Rechargeable Battery is installed or install the Rechargeable
Battery as described on the next page.
PLEASE REFER TO THE FOLLOWING DIAGRAM FOR STEPS 4 THROUGH 7:
4. Slide the TONE/PULSE switch on the side of the Base unit to TONE or PULSE
to match the service provided on your telephone line. If you are not sure of your
service, please contact your telephone company. The factory preset position for
this switch is TONE.
5. Connect one end of the telephone line cord into the TEL LINE jack on the rear
of the base unit and the other end into a modular telephone jack.
6. Insert the small plug at the end of the AC adapter into the DC IN jack located at
the rear of the base unit.
NOTE: Use only the AC adapter provided with your unit.
7. Plug the AC adapter into a standard 120V AC wall outlet.
7
INSTALLATION INSTRUCTIONS
• Base Unit
• Handset Unit
• Rechargeable Ni-MH Battery Pack
(3.6V, 600mAH)
• AC Adapter
(AC120V, 60Hz/DC9V, 300mA)
• Telephone Cord
• Memory Label
HK250.O/M.QXD 9/26/02 3:49 PM Page 7