Filter
Top Products
3.
PIR settings (figure 1)
The jumpers settings are as follows:
Range: High-80 feet
Medium- 50 feet
Low- 30 feet
LED: ON- led will ash when it detects
OFF- led is always dark
Filter: On- set for outdoor use
O-set for indoor use
Reset: 15 seconds to reset after activation
120 seconds to reset after activation
Coding the transmitter:
Note: The transmitters and receivers are preset
at the factory. DO NOT change settings, unless
changing the tune or experiencing false sig-
nals.
1. When looking at the PIR you will see clips on the
sides of the plastic case. Push one of the clips away
from the center of the case and lift out the PIR and
the plastic backing. You will now be looking inside of
the case at the radio transmitter (gure 2)
Figure 1
PIR with cover removed