Filter
Top Products
12
Getting Started
Recalling Stored Numbers from Memory
1. Press the TALK button.
2. Press the MEMO button.
3. Press the keypad button for the number you have stored. The stored number will be dialed
automatically.
EXAMPLE: To recall number 115-1968 stored under the keypad 1 button:
1 - Press the TALK button. 3 - Press the keypad 1 button.
2 - Press the MEMO button.
Redial Feature
1. If you get a busy tone, press the TALK button to hang up.
2. Later, press the TALK button again.
3. Listen for a dial tone.
4. Press the REDIAL button. This will automatically redial the last telephone number you called.
Mixed Mode (Temporary Tone) Dialing
If you only have Pulse (rotary dialing) service in your area set the TONE/PULSE select switch at
the rear of the Base Unit to PULSE position. If you want to access tone dialing mode, press
the TONE button on the Handset and dial the desired number, subsequent digits will be dialed
into Tone mode. Pulse mode will reset after the Handset is returned on-hook.
Using the Headset Feature
Your telephone can utilize a headset (included) to
be connected to your Handset for you to enjoy
hands-free communication.
Insert the small plug on the end of the headset into
the Headset Jack at the right side of the
Handset. Follow the procedures discussed in
“Receiving Calls” and Placing Calls” to receive and
place a call.
NOTE: When you plug the headset plug into the
Headset Jack it automatically mutes the
Microphone and Speaker of the
Handset. Unplug the headset to return
the Handset to normal use.
The Headset Jack is compatible with 2.5 mm
headset plugs only.
TC972 english.qxd 4/13/2004 10:58 AM Page 13