Filter
Top Products
Getting Started
11
Receiving Calls with the Handset on the Base Unit
1. When the phone rings, lift the Handset.
The IN USE LED indicator will light up.
NOTE: The Handset RINGER ON/OFF
switch must be in the “ON” position for
ringer to operate.
2. Start your conversation.
3. To end your conversation, either press the
TALK button or place the Handset on
the Base Unit. If you place the Handset on
the Base Unit CHARGE CRADLE, you
activate the automatic standby feature.
Storing Numbers
1. Be sure the Base Unit IN USE LED
indicator is off and the Handset is in
standby mode.
2. Press the MEMO button.
3. Dial the number you want to store.
4. Press the MEMO button again.
5. Dial the Keypad 0~9 button where you
want to store that number. You will hear
one confirmation “beep.”
6. Repeat steps 1 through 5 to store other
telephone numbers.
EXAMPLE : To store the number 115-1968 under the Keypad 1 button:
1 - Press the MEMO button. 4 - Press the keypad 1 button.
2 - Dial 115-1968. 5 - You have stored 115-1968 under keypad 1 button.
3 - Press the MEMO button again.
A total of 10 telephone numbers can be programmed in memory.
IMPORTANT: The maximum number of digits that can be stored for any phone number is 16 in
PULSE or TONE mode. The maximum number of digits for mixed (TONE and PULSE in
combination) dialing is 15. If you are using a switchboard system to access an outside line (such
as an 8 or 9), press the PAUSE button to store a Pause.
TC972 english.qxd 4/13/2004 10:58 AM Page 12