Filter
Top Products
14
FEATURE BUTTONS
END CALL BUTTON
To end a conversation, press END CALL. In handset mode, the phone will go on-hook
for 2 seconds and then go off hook again. This allows you to make another call. In
speaker or headset mode, the phone will go on hook.
MUTE BUTTON
Press MUTE to speak without the person on the phone hearing your conversation.
“MUTE” will show in the display. To resume the conversation, press MUTE.
FLASH BUTTON
This telephone provides a line break signal for accessing PABX services or for use of
Call Waiting from your local telephone company. If you have Call Waiting service, you
can use the Call Waiting function per the following instructions.
1. While having a conversation, another party calls and you hear a tone.
2. Press FLASH once and release. The first conversation is placed on hold and the
second call can be answered.
3. Press FLASH again and release. You may speak to the first caller again and the
second call is placed on hold.
PAUSE BUTTON
PAUSE allows you to insert a 3.6-second pause in the dialing sequence. This is particu-
larly useful if you are connected to a PABX system where you must dial an access code
(usually the number 9) to obtain an outside line.
1. Press PAUSE and release at any point in the dialing sequence where a pause is
desired.
2. PAUSE can be pressed more than once to create a longer pause.
CALL WAITING OFF
When you come off hook and press this button, the 9125 will dial *70. This is a standard
code to deactivate call waiting. For more information about call waiting, contact your
telephone company.
HEADSET BUTTON
The 9125 supports headsets with a 2.5 mm plug. Be sure you have a headset connected
to the headset jack before using the headset button.
1. Receiving Incoming Calls
a. When the phone rings, press and release HEADSET and speak into the headset
mic.
b. You can adjust the volume of the caller’s voice by pressing the Volume Buttons
on the base of the telephone.
c. After the conversation has finished, press and release HEADSET to hang up.