Filter
Top Products
INSTALLING YOUR T ELEPHONE
Write or type correct telephone number on number card and
fit into finger wheel, aligning notch in number card midway in
the space between the "0" and the "1" hole of the finger wheel.
Position the finger wheel gently under the finger stop. Align the
"0" or "Operator" finger hole at the "9" position on the number
dial. Let the finger wheel drop into position. Now rotate finger
wheel counterclockwise until it clicks into place.
BEFORE USING Y OUR TELEPHONE
This telephone includes a Handset with Receiver Volume Control
that complies with FCC Part 68 requirements mandated by the
Hearing Aid Compatibility Act of 1988.
The Volume Control is a small rotary knob that protrudes from the
inside of the Handset handle. The rotary knob may be
conveniently operated with the thumb, index, or middle finger
while holding the handset.
Rotating the knob toward the Receiver (upper) end of the
Handset will increase the loudness from the Receiver.
Rotating the knob toward the Microphone (lower) end of the
Handset will decrease the loudness from the Receiver.
The Volume Control will not disable the Receiver. The minimum
loudness setting of the Volume control will usually produce a
comfortable listening level for persons with no hearing
impairment.
1. Set the ringer volume control. If the control is set to
OFF, you will not hear the ringer when someone calls you.
2. If your telephone has a TONE-PULSE switch. Set the
switch to match the dialing service from the telephone
company.
• If you have pulse service, set the Tone-Pulse switch
to PULSE.
• If you set the switch for TONE service, you must
have TONE service or you cannot dial.
• If you set the switch for PULSE service and you
have TONE service, you can dial numbers, but you
cannot use distant services, such as bank-by-phone,
unless you press the TONE button.
• If you have PULSE service and your telephone has
a TONE-PULSE switch, you can set the switch to PULSE
and dial a distant service, and then set the switch to TONE
to use the service. BE SURE TO SET THE SWITCH TO
PULSE WHEN YOU FINISH THE CALL.