Filter
Top Products
INSTALLING YOUR T ELEPHONE
DESK INSTALLATION
To install a desk telephone, use the long modular line
cord supplied with your telephone. Plug one end of the
line cord into the connector on the back of your telephone
and the opposite end into the modular wall jack. Your
telephone is ready to use.
To disconnect your telephone,
press the spring clip on the line
cord plug and pull out.
WALL INSTALLATION
To install a modular wall telephone, refer to the diagram to
the right.
• Fit the plug (1) on the back of the
telephone into the jack (2).
• Align slotted holes (3) on the
back of the telephone over the
mounting studs (4).
• Gently pull down on the telephone until it locks in place.
NUMBER CARD
PUSH-BUTTON DIAL TELEPHONES
Write or type correct telephone number on
number card and fit into number card slot
in the telephone faceplate. Insert one end
of the clear plastic retainer in one end of
the slot and, holding the retainer as shown
at right, bend the opposite end down into
the slot and let it snap into place. To
remove the retainer, insert a straightened paper clip into the small
slot in the retainer and pry outward.
ROTARY DIAL TELEPHONES
Rotate the finger wheel clockwise as far as it will go and hold
in this position gently. Insert the straightened end of a paper clip
or similar tool into the pin hole of finger wheel which is now
about 1/4 inch to the left of the finger stop. Press down firmly
on the paper clip and rotate the finger wheel further clock-
wise until paper clip is aligned with the "9" position on the
number dial. Now lift finger wheel from dial.