Filter
Top Products
Customer Assistance WarrantyIntroduction
21
Nothing Comes Close to a Cobra
®
Operation
20
English
Mode Functions
Operation
During memory location scan (while receiving an Incoming
transmission), you can choose from the following:
a.
Press and hold the Talk button to communicate on that
memory location. After 10 seconds of inactivity, unit
restarts scan.
b. Press the Channel Up or Channel Down button to resume
scanning memory locations.
If you press the
Talk button while scanning, but more than
10 seconds after receiving a transmission, you will transmit on
the memory location on which, during scanning, you last received
a transmission. After 10 seconds of inactivity, unit restarts scan.
If you do not press any button within 10 seconds, your radio
will automatically resume scanning memory locations.
During memory location scan (while not receiving a
transmission), you can choose from the following:
a.
Press and hold the Talk button to communicate on the
channel/privacy code that was displayed before you
entered mode functions or memory location on which,
during scanning, you last received a transmission.
After 10 seconds of inactivity, unit restarts scan.
b. Press the Lock/Mode button to proceed to other functions.
c. Press the Hi•Low/Enter button to return to Standby mode
on the channel/privacy code that was displayed before you
entered mode functions or the memory location on which,
during scanning, you last received a transmission.
To reduce the number of memory locations being scanned,
you may de-program any unwanted locations. (See page 15
to de-program a memory location.)
Memory Location Scan
•
Your microTALK
®
radio can automatically scan up to
10 programmed
Memory Locations.
If there are one or fewer memory locations
programmed in your radio, the scan memory
locations option will not be available. To program
at least two memory locations, see program
memory locations on page 13.
To scan memory locations:
1.
Press the Lock/Mode button until the Scan
icon, Memory icon and the memory location
number flash on the display.
2. Press the Channel Up or Channel Down
button to begin scanning memory locations.
The
Scan icon and the Memory icon will
continue to be displayed when memory
location scan is
on. Your radio will continue
to scan memory locations and stop if an
incoming transmission is detected. Your
radio will remain on that memory location
for 10 seconds.
While setting memory location scan, if you
do not press any buttons for 15 seconds,
your radio will automatically return to
Standby mode on the channel/privacy code
displayed before you entered mode functions.
Lock/Mode Button
Scanning Locations
Channel Buttons