Filter
Top Products
TTaallkk BBuuttttoonn
CChhaannnneell BBuuttttoonnss
CChhaannnneell NNuummbbeerr
TTwwoo IInncchheess ((ffiivvee
ccmm)) ffrroomm MMoouutthh
LLiisstteenniinngg
Customer Assistance WarrantyIntroduction
55
NNootthhiinngg
Comes Close to a Cobra
®
OOppeerraattiioonn
44
EEnngglliisshh
UUssiinngg YYoouurr RRaaddiioo
Communicating with Another Person
••
To talk to another person:
1. Press and hold the Talk button.
2. With the microphone about two inches
(five cm) from your mouth, speak in a
normal voice.
3. Release the Talk button when you are
finished talking and listen for a response.
You cannot receive incoming calls while
pressing the Talk button.
Both radios must be tuned to
the same channel/privacy code
to communicate.
Channels
••
To select a channel:
With the radio on, select any of the 22
channels by pressing the Channel Up or
Channel Down button.
Both radios must be tuned to the
same channel to communicate.
Channels 1 through 7 are shared by FRS and
GMRS. Channels 8 through 14 are FRS only.
Channels 15 through 22 are GMRS only.
See page 21 for FRS/GMRS frequency
allocations and compatibility charts.
Listening for a Response
••
When you are finished talking:
Release the Talk button to receive incoming
transmissions. Your microTALK
®
radio is
always in Standby mode while the Talk or
Call buttons are not pressed.
LLooww PPoowweerr IIccoonn
HHii PPoowweerr IIccoonn
OOppeerraattiioonn
EEnntteerr//HHii••LLooww BBuuttttoonn
Volume
••
To adjust the volume:
Rotate the On/Off Volume knob.
Call Button
••
To alert another person that you are calling:
Press and release the Call button.
The other person will hear a two second
call tone. This tone is used only to establish
voice communications.
See page 19 on how to select from
10 available call tone settings.
Selectable High•Low Power Output
••
When in close proximity to another party or
during favorable conditions, you can switch
from High to Low Power to extend battery life.
This feature applies to GMRS Channels
1 through 7 and 15 through 22 only.
Channels 8 through 14 operate
exclusively on low power.
To toggle between high and low power:
Press the Enter/Hi•Low button for
two seconds.
When using Channels 1 through 7 and
15 through 22 on high power, the Hi icon
will be visible on the display.
When using those channels on low power
and on Channels 8 through 14, the Low icon
will be visible on the display.
Display Illumination
••
To illuminate your display:
Press and release the Light/Max Range
button to illuminate the display for
10 seconds.
LLiigghhtt//MMaaxx RRaannggee
VVoolluummee KKnnoobb
CCaallll BBuuttttoonn