Filter
Top Products
10
OPERATING PROCEDURE TO RECEIVE
1. Place the WX/CB Switch in the CB position.
2. Turn the set ON by pressing the POWER Switch.
3. Adjust the VOLUME for a comfortable listening level.
4. Set the Channel selector switch to the desired channel.
5. Set RF GAIN fully clockwise.
6. Set the Mode Selector to desired mode for LSB, AM or USB.
7. Adjust the VOICE LOCK control to clarify the SSB signals or to optimize AM
signals.
8. Listen to the background noise from the speaker. Turn the SQUELCH control
slowly clockwise, until the noise JUST disappears. (No signal should now be
present.) Leave the control at this setting. The SQUELCH is now properly adjusted.
The receiver will remain quiet until a signal is actually received. Do not advance
the control too far, or some of the weaker signals will not be heard.
Section IV Operation (Continued)
OPERATING PROCEDURE TO TRANSMIT
1. Select the desired channel of transmission.
2. Set the DYNAMIKE control fully clockwise.
3. If the channel is clear, press the push-to-talk switch on the microphone and speak
in a normal voice.
The S-RF meter will indicate relative power output and the modulation meter will
indicate percentage of modulation as you speak into the microphone.
CAUTION
Be sure the antenna is properly connected to the radio before transmitting.
Prolonged transmitting without an antenna or a poorly matched antenna
could cause damage to the transmitter.
OPERATING PROCEDURE TO RECEIVE WEATHER BAND
1. Place WX/CB Switch in the WX position.
2. Turn the Weather Channel Selector (1-7) until you find the Weather
Channel with the clearest reception. Sometimes more than one channel
can be received depending on your location in the broadcast area; how-
ever, the closest broadcast to you will be the one with the clearest signal
(the least static or background noise).