Filter
Top Products
9 – ENGLISH
potentially result from misuse.
Using the volume reset override
In standard mode, the phone will reset to normal sound levels when you hang
up. This allows people who do not require the level of amplification offered
on the phone to use it. If you would like to override the reset, simply turn the
AUTO AMPLIFY
Oswitch on the back of the phone to “ON” using the tip of a
pencil or paper clip
IMPORTANT: When the AUTO AMPLIFY
Oswitch is in the “ON” position, you do
not need to press the “AMP” (amplify) button. Your amplification setting will
remain as set. On any call, you can temporarily turn OFF and turn back ON the
AUTO AMPLIFY feature by pressing the “AMP” button. If you do not utilize the
Reset Override feature you will need to press the AMP button to manually turn
on the amplification during calls.
NOTE: When the amplifier turns on, the red indicator lamp near the AMP button
will be lit. The AUTO AMPLIFY
Oswitch will be pre-set to the OFF position at
the factory
.
Using your CSC600 Amplified Phone with hearing aids
Your CSC600 Phone can be used with hearing aids equipped with a
telecoil (T-coil). Adjust your hearing aid “T-switch” to the “T” position.
Make sure to hold the handset close to your hearing aid.
Using the Outgoing Speech Volume
You can adjust the sending volume (outgoing volume up to 12 dB
of gain) by using the Speech Volume Control located on the right
side of your CSC600 Phone. If your voice is faint or weak, adjust the
volume to “HI”. You can also decrease the volume as well. There are
three levels available “LO, NORMAL & HI”.
PROGRAMMING MEMORY DIAL BUTTONS
These memory dial buttons are empty. Should you choose to use this
feature you will need to select the telephone numbers for each button.
It is recommended you store these numbers during installation.
Your CSC600 Phone allows you to program five frequently dialed
numbers into memory for future use (30 digits maximum for each
button).
NOTE: We do not recommend that you program 911 into any
memory buttons!
To program your one-touch memory dial buttons please follow
instructions next page:
1 Lift the handset.
2 Press the PROG (program) button.