Filter
Top Products
6 – ENGLISH
Bottom of base
Desk / Table Mounting
1. Plug the AC power adapter into the
jack on the bottom of the base,
then plug the AC adapter into a
standard electrical outlet or
surge protector.
NOTE: The adapter is required for the phone to work.
Installing Batteries Three AAA re-chargeable Ni-MH batteries
come with your phone. You must install the batteries before
using your phone.
1. Remove the battery compartment cover by sliding it
downwards.
2. Insert the new batteries. Be sure to observe
battery polarity as imprinted on the inside of the
compartment.
3. Replace the battery compartment cover by sliding
upward until it clicks into place.
NOTE: The batteries need to be replaced if they do not recover
their full storage capacity after recharging. Check the battery
icon on the LCD to see the battery charge level. When replacing
the batteries, always use good quality Ni-MH AAA re-chargeable
batteries.
Charging the Handset
1. Place the handset into the base. The LCD
screen will light up and you will hear a beep
to indicate charging has begun.
2. Important: Before initial operation, you
should fully charge the handset for at
least 15 hours.
3. After the batteries are fully charged, begin the
registration process as described on page 8.