Filter
Top Products
CHAPTER 5
(CONTINUED)
Voice Activated answering
(RC200 only)
1. The voice activated Answering feature
has been preset to OFF in the factory.
To activate this feature, see page 5.
2. Say "Hello" or whistle loudly, between
rings. (If a headset is used, answer by
speaking into the headset microphone.)
3. Use the remote control, or press the
ON/OFF button on the console to hang up.
Please Note:When the party that called
you hangs up, the telephone company
switching office may re-establish a dial
tone on your line.
When dial tone returns, your RC200
will hang up automatically. Prior to
hanging up, the RC200 emits two short
beeps as a reminder.
D. Other Operations
Redialing the last number dialed
1. Press the REDIAL
button on the keypad.
OR
2. Press and hold the
Remote Transmitter for
3 seconds, until the
ON/OFF indicator on
DIALOGUE RC
turns on.
Flash button
The flash button is used to access special tele-
phone functions and services available from
your local phone company, such as call waiting,
3–way calling, and others. Call your phone
company for more information.
FLASH/PAUSE
REDIAL
MUTE
ON/OFF
HEADSET
MIC
Figure 20
FLASH/PAUSE
REDIAL
ON/OFF
Figure 21
If you have the RC200, you can use the Flash
feature with the Remote Transmit--ter.Turn
the Remote Flash switch on (see Chapter 4 sec-
tion C).When you are on the phone line, press
the Remote Transmitter button twice in suc-
cession, within three seconds, to generate the
“flash”.
Voice Mail Indicator (VMI)
If you subscribe to voice mail service from
your phone company, the FLASH/PAUSE light
flashes and the RC beeps (once every 3.5 min-
utes) to inform you that you have voice mail
messages.You also hear a special "stutter" dial
tone sent from the phone
company.To retrieve your mes-
sages,follow the instructions
provided by your phone
company. Making an
outgoing call cancels the
indicator light.
Unanswered Call
Indicator
If the RC rings three or more
times and is not answered,
the FLASH/PAUSE light
flashes to indicate that you missed
a call.Turning on the RC cancels the indicator.
Telebanking and Credit Card Calling
You can transmit account or personal
identification numbers (PIN) from the
RC by pre–storing them in memory.
1. Program account or PIN numbers into
a memory location in advance by
following the same steps you would
program a phone number.
2. When the automated phone system
requests it, press the memory button
where your account number or PIN is
stored.
REDIAL
MUTE
ON/OFF
HEADSET
FLASH/PAUSE
REDIAL
MUTE
ON/OFF
HEADSET
FLASH/PAUSE
Figure 22
Figure 23
8