Filter
Top Products
14
I. Hold Button
To put the line on hold, simply press
the HOLD button and return the
handset to its cradle. Notice the red
light HOLD indicator. When you
pick up an extension phone on the
same line, the P300 will disconnect.
Putting the call on hold also mutes
the handset.
J. Last Number Redial
Button
The P300 phone remembers the last
number dialed from the phone (up to
32 digits). Lift the handset and simply
press the REDIAL button to dial the
last number dialed.
BOOST
FLASH
RINGER
PITCH
Fig. 13 – Redial button
FLASH
BOOST
CLARITY
POWER
RINGER
PITCH
Fig. 14 – Flash button
K. Flash Button
The flash feature is used to access
special telephone functions and ser-
vices available from your local phone
company, such as call waiting, 3-way
calling and others. Press this button
to activate the flash feature.
Troubleshooting
If any problem should arise during use of your P300 phone, try the suggestions listed
below. Should the difficulty persist, contact Clarity technical support at 800-426-3738 for
assistance.
• No dial tone: Check all phone cord connections.
• No number dialed when memory button pressed: No number stored in
that memory button. See "Programming The Photo Directory," p. 12.
• Call cannot be dialed, or is dialed slowly: See "Installation" section (p. 11) to
reset the dial mode switch.
• No audible ring: Make sure the ringer is not set to "Off" position.
• No amplification: BOOST must be activated. See "Boost Button" section (p. 13).
• Static/Interference on line: Check cords and connections. Relocate phone to
different phone jack.
• How to remove memory storage card and cover: Place thumb and fore-
finger in center of card. Press fingers toward each other to pull card tabs from
underneath casing.
Telephone Operations
BOOST
CLARITY
POWER
FLASH
Fig. 12 – Hold light