Filter
Top Products
14
H. Hold Button
To put the line on hold, simply press
the HOLD button and return the
handset to its cradle. Notice the red
light HOLD indicator. When you
pick up an extension phone on the
same line, the P400 will disconnect.
Putting the call on hold also mutes
the handset.
I. Last Number Redial Button
The P400 phone remembers the last
number dialed from the phone up to
32 digits. Lift the handset and simply
press the REDIAL button to dial the
last number dialed.
BOOST
FLASH
Figure 13
FLASH
BOOST
CLARITY
POWER
Figure 14
J. Flash Button
The flash feature is used to access
special telephone functions and ser-
vices available from your local phone
company, such as: call waiting, 3-way
calling and others. Press this button
to activate the flash feature.
Troubleshooting
If any problem should arise during use of your P400 phone, try the suggestions
listed below. Should the difficulty persist, contact Clarity or your authorized
dealer for assistance.
SYMPTOM CAUSE AND CORRECTIVE ACTION
No dial tone Check all phone cord connections.
No number dialed when No number stored in that memory button.
memory button pressed See “Programming The Photo Directory”, p. 12.
Call cannot be dialed, or See “Installation” section to
is dialed slowly reset the dial mode switch, p. 11.
No audible ring Make sure the ringer is not set
to “Off” position.
Telephone Operations
BOOST
CLARITY
POWER
FLASH
Figure 12