Filter
Top Products
10
Installation
Follow the steps below to connect
and install your P400 telephone.
A. Desk Mounting
1. Set the dial mode switch to T
(tone) if you have touch tone service.
Set the switch to P (pulse) if you
have pulse (rotary) dialing.
2. Connect telephone line cord to
telephone as shown in figure 3.
3. Connect handset cord to the
telephone as shown below.
4. Lift the handset and listen for a
dial tone.
5. Your P400 is ready to use.
$$
Fig. 3 – Connections and installation
B. Wall Mounting
1. Pull the handset hook out and
reverse its position so that the
hook points up and will hold the
handset when you hang up as shown
in figure 4.
2. Insert the tabs of the phone base
into the slots in the lower position
of the base. Push in and down firmly
until it snaps into place as shown
in figure 5.
1
4
1
4
Fig. 4 – Handset hook change